The Intrinsically Safe E111 is ATEX and IECEx approved for use in potentially explosive gas/vapour and dust atmospheres. This heavy-duty version of the E101 sensor with a stronger 12.6mm push rod, recommended for applications where vibration is an issue or there is a need for longer travel sensors, mounted horizontally, and supported between rod eyes. Affordable, durable, high-accuracy position sensor designed for industrial and scientific feedback applications The unit is highly compact and space-efficient, being responsive along almost its entire length Linear output proportional to displacement Output calibrated to the travel required, from 0-5mm to 0-800mm and with full EMC protection built in Very robust, the body and push rod being made of stainless steel for long service life and environmental resistance Overall performance, repeatability and stability are outstanding over a wide temperature range The sensor is easy to install with mounting options including M8 rod eye bearings and body clamps The push rod can be supplied free or captive, with female M8 thread, an M8 rod eye, or dome end Captive push rods can be sprung loaded, in either direction, on sensors up to 300mm of travel The E111 also offers a range of mechanical options, environmental sealing is to IP67 Positek intrinsically safe sensors are designed to be used with a galvanically isolated amplifier. Approved galvanic isolation amplifiers (X005) are available from Positek; there is a choice of 0.5-9.5V or 4-20mA transmission outputs. The sensor can be installed with a cable length up to 1km between the sensor and the amplifier. Click the below buttons to view datasheet and other helpful guides: Drawing, Datasheet, Installation Guide & P/N Configurator Body Clamps